Soldering enamel coated wire can be challenging, but if you have the right tools and know a few tricks, you won’t have any problems! Over at Kuaike Precision Alloy a little advice on how to solder enamel wire without hurting it.
We need to be careful with it when soldering enamel coated wire. First, you will need a soldering iron, solder, flux, and an extra pair of hands to hold the wire. Be sure to sand a little of the enamel off before soldering. The enamel can prevent solder from adhering to the wire.
Use a low heating setting on your iron so you don’t melt the enamel on the wire and work quickly. This will offer some protection from overheating the wire. Adding flux to the wire before you solder can also provide a better hold for the solder without damaging the enamel. Be compassionate when soldering, and use only medium pressure, because the enamel can crack.
It’s very important to have the right tools when soldering enamel covered wire. You may also want to use a good fine-pointed soldering iron for delicate wiring. A second set of hands can hold the wire in place while you work. Just the right solder and just the right flux can give you stronger solder joints.
One all-too-common mistake that people make is generating too much heat, which can melt the enamel and injure the wire. Another mistake was not removing enough of the enamel coating before soldering. Then you won't make the following mistakes when soldering the enamel wire with the help of Kuaike Precision Alloy.
Copyright © Kuaike Precision Alloy (Shanghai) Co., Ltd. All Rights Reserved
EN
AR
DA
NL
FI
FR
DE
EL
HI
IT
JA
KO
NO
PL
PT
RO
RU
ES
SV
TL
IW
ID
SR
SL
UK
VI
HU
MT
TH
TR
AF
MS
GA
AZ
MN
MY
KK
UZ
KY
BN
